if I wanted to put my DHT22 far away from my arduino and breadboard could I solder wires directly to the Dht22 pins and then have the other ends going into the appropriate places on the breadboard? I’m completely new to this, so I apologize if this is an obvious question.
No problem, you can put leads on the Virtuabotix DHT22 or DHT11, but I wouldn’t recommend a length of more than 12 to 18 inches since much more than that would likely have an adverse effect on communication with the device. You are welcome to try any length though (wires are easy enough to make shorter), just let me know if you get it working at any longer lengths then mentioned, I would love to know how far you get it.
hey thanks! Will do, i’ll keep you updated.